In fact, the scope of the maintenance of the labeling machine is relatively wide. It can include many aspects, such as correct installation, correct operation, etc., which are all within the scope of maintenance, and some before and after use. Matters need attention, so do you know about the maintenance knowledge of the labeling machine? Let’s take a look together below:
1. The labeling machine needs to ensure the alignment of the labels when adding labels. The first label should be kept between 0.1~0.2mm between the guide forks and the fingers should be evenly pressed on the edge strips. After the fingers are opened, the roller sponge needs to press the label on the bottle. Finally, to ensure that the label will not be skewed, the vertical and horizontal positioning plate must be adjusted.
2. Make sure that the label is properly pressed when adding labels. If the pressure is too large, it will cause misalignment of the label when labeling. At the same time, accelerating the label hook will also cause a certain amount of wear. Secondly, the labeling detection when the labeling machine and the flat labeling machine are working. Take the automatic flat labeling machine as an example. When the article reaches the labeling position through the conveyor belt, it is necessary to ensure that the label brush vertically and smoothly presses the label evenly. In the process, if the pressure is insufficient or the pressure is too high, the labeling position will be skewed. Therefore, the operator needs to pay attention to this point. When the labeling is found to be skewed, the standard brush pressure should be adjusted. Familiarity is the prerequisite for driving. The details determine the duration of use. A little more care will definitely bring greater value.
The introduction about the labeling machine that needs care is here. For details, please consult this site: http://www.ublpacking.com
Post time: Jan-10-2022